PRO1 Seated Assembly

Short assembly steps will be required when the PRO1 Seated machine arrives. The following will show how to assembly the machine.
Tools Required:
  • Torque wrench set 48 ft-lbs/65 Nm
  • 12"/30.5 cm Ratchet extension
  • Long Center Punch
  • Ratchet
  • 5/16"/8 mm Allen hex bit
  • Cordless Drill W/Phillips Bit or Phillips Screw Driver
Parts Required:
  • Washer, Flat 3/8" (Qty. 4)
  • Washer, Split 3/8" (Qty. 4)
  • Screw, 3/8"-16 x 1" Socket (Qty. 4)
  • Screw, M5 x 12mm Phil Black (Qty. 4)
  • PRO1 to PRO2 Base Spacer (Qty. 2)
  1. The PRO1 Seated machine will be received as shown and will need the pivot hardware at the front of the base frame removed, then placed to the side using a ratchet, 12" ratchet extension and 5/16" hex bit.
  2. Warning: It is highly recommended that two people are used for the following steps.
    Carefully lift and place the mast in front of the round cross tube and in-between the front square tubes.
  3. While the second person is still holding the main unit and mast, place a PRO1 to PRO2 Base spacer on the left and right side between the mast and the square tube weldments as shown.
  4. Attention: Second person should still be holding the main unit and mast.
    Starting on the right side insert a center punch through the spacer and into the mast in the hole nearest to the round cross tube, then use a ratchet extension with attached 5/16" hex bit and loosely insert a 3/8-16 x 1" socket screw, 3/8" split washer and 3/8" flat washer into the front hole nearest the transport wheels through the spacer and into the mast as shown.
  5. Remove the center punch and again use a ratchet extension with attached 5/16" hex bit and loosely insert a 3/8-16 x 1" socket screw, 3/8" split washer and 3/8" flat washer into the hole where the center punch was located as shown.
  6. Attention: The second person will no longer need to hold the main unit and mast.
    Go to the left side and continue to loosely insert a 3/8-16 x 1" screw, 3/8" split washer and 3/8" flat washer into the front and rear holes through the spacer into the mast. NOTE: Any additional packaging may be removed from the machine at this time.
  7. Starting on the left side, then the right use a torque wrench set at 48 ft-lbs/ 65 Nm, 12" ratchet extension and 5/16" hex bit to tighten and secure the mast to the base frame.
  8. Rotate the console mounting bracket upward, then insert the machine communication cable to the RJ45 connector on the back of the console.
  9. Use a phillips screw driver or cordless drill with attached phillips bit to secure the console to the mounting bracket with (Qty. 4) M5 x 12mm Phil Black Zinc screws.
    The machine is now ready to be moved to the customer preferred location.
Parent topic: Assembly and Relocation