Install SE4 Cables to Comport Panel

The following procedure shows how to install cables for the SE4 Console. If SL Console is being installed, skip to Attach Console Weldment.
  1. Remove screws securing comport panel to base frame using a Phillips screwdriver.
    Note: Save hardware for reattaching comport panel.
  2. Remove plugs from the comport panel.
    Item Description Qty.
    1 Comport Panel 1
    2 SCREW: M4.2 X 0.7 6G6G X 19, DIN, PHL, PAN, AB, ST, ZB 2
    3 Plug, COAX
    4 Plug, RJ45 Receptacle 1
  3. Route SE4 cables down through the base frame and out the comport hole.
    Tip: There is a pull wire pre-installed in the frame to assist with SE4 cable installation. Twist the pull wire around the ends of the SE4 cables and pull from the other end to install the cables through the frame.
    Item Description Qty.
    1 SE4 Cables (CAT5E and COAX) 2
    2 Frame 1
  4. Plug cables into couplers. Insert couplers into comport panel. Use an 11 mm wrench for coax.
    Item Description Qty.
    1 Comport Panel 1
    2 Coupler, COAX 1
    3 Cable, COAX 1
    4 Coupler, CAT5E 1
    5 Cable, CAT5E 1
  5. Install screws to re-attach comport panel to base frame using a Phillips screwdriver.
    Item Description Qty.
    1 Comport Panel 1
    2 SCREW: M4.2 X 0.7 6G6G X 19, DIN, PHL, PAN, AB, ST, ZB 2
    13 in-lb / 1.5 Nm
Parent topic: Assembly Procedure