How to Stabilize the Recumbent Cycle

Read the entire manual before setting up the cycle. After following all Safety Instructions, move the cycle to the location where it will be used. Allow a clearance of 2 ft. (0.6 m) in the directions the cycle is accessed from and 3 ft. (1 m) between the front or rear of the cycle or any other objects.

After placing the unit in position, check the unit’s stability by attempting to rock it from side to side. Any slight rocking indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut with an open end 17 mm wrench and rotate the stabilizing foot to lower it. Verify that the cycle is stable, and repeat the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the stabilizing bar.