Assembly Procedure

Two people are recommended for this procedure.

Tip: Read and understand all instructions thoroughly before assembling this unit. Check all items carefully. If there is damage, see the Customer Service section of this manual for proper procedure to return, replace, or reorder parts.

In this section:

  1. Unpacking and Disposal of Packaging
  2. Attach Rear Stabilizer
  3. Attach Front Stabilizer
  4. Hardware Tightening Sequence for the Stabilizers
  5. Install Seat Carriage
  6. Attach Seat Stop
  7. Attach Seat Handlebar
  8. Attach Seat Cushion
  9. Attach Plunger Assembly
  10. Attach Cup Holder
  11. Attach Seat Back
  12. Attach Seat Extrusion Rear End Cap
  13. Install SE4 Cables to Comport Panel
    The following procedure shows how to install cables for the SE4 Console. If SL Console is being installed, skip to .
  14. Attach Console Weldment
  15. Attach Lower Console Back Shroud
  16. Install Ground Cable
  17. Ferrite Installation
  18. Base to Console Connections
  19. Attach Console: SL or SE4
  20. Attach Console Back Shroud
  21. Attach Pedals
  22. Test Unit For Proper Operation