Assembly Procedure

Two people will be required for this procedure.

Tip: Read and understand all instructions thoroughly before assembling this unit. Check all items carefully. If there is damage, see the Customer Service section of this manual for proper procedure to return, replace, or reorder parts.

In this section:

  1. Unpacking and Disposal of Packaging
  2. Remove Motor Cover Top Shroud
  3. Attach Upright Weldments to Base
  4. Attach Bridge Weldment to Upright Weldments
  5. Tighten Screws Securing Upright Weldments to Base
    Secure both upright weldments to base using a 13 mm socket. Tighten hardware in the following order:
  6. Cable Connections: Base to MDB PC Board
  7. Ferrite Installation - Motor Pan
  8. Install SE4 Cables to Comport Panel
    The following procedure shows how to install cables for the SE4 Console. If SL Console is being installed, skip to .
  9. Attach Console Weldment to Bridge Weldment
  10. Install Ground Cable
  11. Attach Upper Bridge Shroud to Bridge Weldment
  12. Attach Lower Bridge Shroud to Bridge Weldment
  13. Attach Console Lower Shroud
  14. Ferrite Installation - Bottom of Console Weldment
  15. Cable Connections: Base to Console
  16. Attach Console: SE4
  17. Attach Console: SL
  18. Attach Console Back Shroud to Console Weldment
  19. Secure Motor Cover Front Shroud
  20. SE4 Power Supply Cable and Ferrite Installation
    The following procedure shows how to install power supply cable and ferrite for the SE4 Console. If SL Console is being installed, skip this step and continue to .
  21. Secure Motor Cover Top Shroud
  22. Attach Power Cord
    Follow these steps if power cord is not already installed:
  23. Test Unit For Proper Operation