Assemble Frame Components

  1. Place shims under the feet of the tower frame.
    Item Description Qty.
    1 Tower Frame 1
    2 Shim 2
  2. Install screws and washers securing the front support leg to the tower frame using an 8 mm Allen wrench.
    Item Description Qty.
    1 Support Leg, Front 1
    2 Washer, Flat 3/8" 3
    3 Screw, M10 x 1.5, 25 mm 3

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

  3. Install screws and washers securing the rear support leg to the tower frame using an 8 mm Allen wrench.
    Item Description Qty.
    1 Support Leg, Rear 1
    2 Washer, Flat 3/8" 3
    3 Screw, M10 x 1.5, 25 mm 3

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

  4. Install screws and washers securing the seat frame assembly to the tower frame using an 8 mm Allen wrench.
    Item Description Qty.
    1 Seat Frame Assembly 1
    2 Screw, M10 x 1.5, 25 mm 4
    3 Washer, Flat 3/8" 4

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

  5. Install screws and washers securing the upper pulley assembly to the tower frame using an 8 mm Allen wrench.
    Item Description Qty.
    1 Upper Pulley Assembly 1
    2 Screw, M10 x 1.5, 25 mm 4
    3 Washer, Flat 3/8" 4

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

  6. Install screws and washers securing the pulley bracket assembly to the tower frame using an 8 mm Allen wrench.
    Item Description Qty.
    1 Pulley Bracket Assembly 1
    2 Screw, M10 x 1.5, 25 mm 3
    3 Washer, Flat 3/8" 3

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

  7. Install screws, washers, and locknuts securing the roller pad bracket and foot support to the seat frame assembly using an 8 mm Allen wrench and a 17 mm wrench.
    Item Description Qty.
    1 Roller Pad Bracket 1
    2 Foot Support 1
    3 Screw, M10 x 1.5, 75 mm 2
    4 Screw, M10 x 1.5, 80 mm 1
    5 Washer, Flat 3/8" 6
    6 Nut, M10 x 1.5, Hex Nylock 3

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

    Note: Check orientation of roller pad bracket and foot support. The roller pads and foot grips should face towards the user and away from the tower.

    Correct Orientation

    Incorrect Orientation

Parent topic: Assembly Procedure