Assemble Frame Components

  1. Install screws, washers, and locknuts securing the bottom cross brace to the bottom of the main frame using an 8mm Allen wrench and 17mm wrench.
    Item Description Qty.
    1 Bottom Cross Brace 1
    2 Main Frame 1
    3 Screw, M10 x 1.5, 120mm 2
    4 Washer, Flat 3/8" 4
    5 Nut, M10 x 1.5, Hex Nylock 2

    Hand tighten hardware.

  2. Install screws, washers, and locknuts securing the tower frame to the bottom cross brace using an 8mm Allen wrench and 17mm wrench.
    Item Description Qty.
    1 Tower Frame 1
    2 Bottom Cross Brace 1
    3 Screw, M10 x 1.5, 110mm 1
    4 Washer, Flat 3/8" 4
    5 Nut, M10 x 1.5, Hex Nylock 2
    6 Hole Plug, ½" 2

    Hand tighten hardware.

  3. Install screws, washers, and locknuts securing the front cross brace to the main frame using an 8mm Allen wrench and 17mm wrench.
    Item Description Qty.
    1 Front Cross Brace 1
    2 Main Frame 1
    3 Screw, M10 x 1.5, 30mm 2
    4 Washer, Flat 3/8" 4
    5 Nut, M10 x 1.5, Hex Nylock 2

    Hand tighten hardware.

  4. Install screw, washers, and locknut securing the work arm stop to the main frame using an 8mm Allen wrench and 17mm wrench.
    Item Description Qty.
    1 Front Cross Brace 1
    2 Main Frame 1
    3 Work Arm Stop 1
    4 Screw, M10 x 1.5, 100mm 1
    5 Washer, Flat 3/8" 2
    6 Nut, M10 x 1.5, Hex Nylock 1

    Hand tighten hardware.

  5. Install screws and washers securing the front cross brace to the tower frame using an 8mm Allen wrench.
    Item Description Qty.
    1 Front Cross Brace 1
    2 Tower Frame 1
    3 Screw, M10 x 1.5, 25mm 4
    4 Washer, Flat 3/8" 4

    Hand tighten hardware.

  6. Tighten the hardware from Steps 1-5 to 20-25 ft-lb (27.1-33.9 Nm).
  7. Slide pivot shaft through the flange bearings in the main frame. Place seat frame over the pivot shaft.
  8. Install screws and washers securing the seat frame to the main frame using an 8mm Allen wrench.
    Item Description Qty.
    1 Seat Frame 1
    2 Main Frame 1
    3 Pivot Shaft, 19mm 1
    4 Screw, M10 x 1.5, 25mm 2
    5 Washer, Flat 3/8" 2

    Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).

    Note: Slide bumper sleeve on the seat frame behind the main frame back pad weldment when installing.
Parent topic: Assembly Procedure