Install Pads

  1. Install screws and washers securing the back pad to the main frame back pad weldment using an 8mm Allen wrench.
    Item Description Qty.
    1 Back Pad 1
    2 Washer, Flat 3/8" 2
    3 Screw, M10 x 1.5, 30mm 1
    4 Screw, M10 x 1.5, 70mm 1
    5 Hole Plug, 1" 1

    Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).

  2. Install hole plug to the main frame back pad weldment using a rubber mallet.
  3. Install screws and washers securing the seat pad to the seat frame using an 8mm Allen wrench.
    Item Description Qty.
    1 Seat Pad 1
    2 Washer, Flat 3/8" 4
    3 Screw, M10 x 1.5, 30mm 4

    Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).

  4. Slide shaft collar and roller pad onto the leg curl assembly.
  5. Install screw and roller pad plate securing the roller pad to the leg curl assembly using an 8mm Allen wrench.
    Item Description Qty.
    1 Shaft Collar 4
    2 Roller Pad 4
    3 Roller Pad Plate 4
    4 Screw, M10 x 1.5, 30mm 4
    5 Bearing Housing Cap 4

    Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).

  6. Tighten set screws in shaft collars to 8-10 ft-lb (10.8-13.5 Nm) using a 4mm Allen wrench.
  7. Install bearing housing caps to roller pads using a rubber mallet.
  8. Repeat Steps 4-7 to install the remaining roller pads onto the leg curl and leg extension assemblies.
Parent topic: Assembly Procedure