Home page logo
Home page logo
LifeFitness.com
  • Support Hub
  • Parts
  • Table of Contents
  • العربية — Arabic Deutsche Español English français italiano 日本語 — Japanese Korean Nederlands português русский — Russian Turkey 中文 — Chinese
  • Log In

Activate Cross-Trainer

Life FitnessActivate Cross-TrainerOSX Assembly Instructions
  • Chapter 1: Getting Started
    • 1.1: Safety Instructions
    • 1.2: Consignes de Sécurité
    • 1.3: Set-Up
      • 1.3.1: Electrical Power Requirements
      • 1.3.2: Grounding Instructions
      • 1.3.3: How to Position and Stabilize the Unit
      • 1.3.4: Safety Clearances
      • 1.3.5: Power Switch
      • 1.3.6: Power Cord Routing
      • 1.3.7: Immobilization Method
  • Chapter 2: Service and Technical Data
    • 2.1: Preventive Maintenance Schedule
    • 2.2: Preventive Maintenance Tips
    • 2.3: Approved and Compatible Cleaners
    • 2.4: Troubleshooting the Treadmill
    • 2.5: How to Obtain Product Service
    • 2.6: How to Adjust and Tension the Striding Belt
    • 2.7: Belt Tensioning Bolts
    • 2.8: Tracking (Centering) a Striding Belt
    • 2.9: Tensioning an Existing Striding Belt
  • Chapter 3: Assembly
    • 3.1: Component and Hardware List
    • 3.2: Tools Required
    • 3.3: Remove Motor Cover
    • 3.4: Install Uprights
    • 3.5: Install Front Crossbar
    • 3.6: Install Bridge
    • 3.7: Tighten Upper Hardware
    • 3.8: Tighten Lower Hardware
    • 3.9: Install Plastic Grommets
    • 3.10: Install Upper Dashboard Tray
    • 3.11: Install Console
    • 3.12: Console Connections
    • 3.13: Install Lower Dashboard Tray
    • 3.14: Install Rear End Caps
    • 3.15: Install Motor Cover
    • 3.16: Install Front End Caps

Service and Technical Data

In this section:

  1. Preventive Maintenance Schedule
  2. Preventive Maintenance Tips
  3. Approved and Compatible Cleaners
  4. Troubleshooting the Treadmill
  5. How to Obtain Product Service
  6. How to Adjust and Tension the Striding Belt
  7. Belt Tensioning Bolts
  8. Tracking (Centering) a Striding Belt
    Two people are needed to perform this procedure.
  9. Tensioning an Existing Striding Belt

Was this helpful?

Thanks!

Service Hub

  • Self Service
  • Order Parts
  • Warranties

Additional Support

  • Become a Service Partner
  • Request Service
  • Product Registration
  • Contact Us
  • Privacy Policy
  • Terms and Conditions

Copyright © 2026 Life Fitness

Building One-Page View

This might take a few seconds.