Install Console Weldment

  1. Route cables up through console weldment.
    Item Description Qty.
    1 Cables -
    2 Console Weldment 1
    Note: Ground cable routes up through and out back of console weldment.
    Item Description Qty.
    1 Ground Cable 1
    2 Console Weldment 1
  2. Install nuts securing console weldment to monocolumn using a 13mm wrench.
    Item Description Qty.
    1 Console Weldment 1
    2 Monocolumn 1
    3 Nut, M8 x 1.25-6H, DIN, UNF, HEX, Locknut 4

    Tighten hardware to 25 ft-lb / 34 Nm.

  3. Pull cables through console weldment until they extend approxitely 6 in / 15.2 cm past top of weldment. Push remaining cable length down console weldment and monocolumn.
    Item Description Qty.
    1 Cables -
    2 Console Weldment 1
  4. Note: The following step is only for units with SE4 Consoles. If SL Console is being installed, skip to step 5.
    Press cupholders upper shroud into monocolumn and shrouds.
    Item Description Qty.
    1 Cupholders Upper Shroud 1
    2 Monocolumn 1
    3 Cupholders Lower Shroud 1
    4 Bridge Front Lower Shroud 1
  5. Press console front filler shroud into console weldment.
    Item Description Qty.
    1 Console Front Filler Shroud 1
    2 Console Weldment 1
  6. Install screw securing ground cable to console weldment using an 8mm socket wrench.
    Item Description Qty.
    1 Ground Cable 1
    2 Console Weldment 1
    3 Screw, #10 x 6 UNS, HXW, L, B, ST, GR 1

    Tighten hardware to 2.6 ft-lb / 3.5 Nm.

Parent topic: Assembly Procedure