Install Footboard

  1. Slide footboard adjustment assembly and footboard adjustment weldment through footboard linkage weldments, footboard crossmember assembly, footboard middle weldment, and shaft collars. Tighten set screws in shaft collars using a 4mm Allen wrench.
    Note: Verify footboard adjustment assembly (with handle) is installed on the left side of the unit.
    Item Description Qty.
    1 Footboard Linkage Weldment 2
    2 Footboard Adjustment Assembly 1
    3 Footboard Adjustment Weldment 1
    4 Footboard Middle Weldment 1
    5 Footboard Crossmember Assembly 1
    6 Shaft Collar 4

    Tighten hardware to 8-10 ft-lb / 10.8-13.5 Nm.

  2. Align footboard assembly with side frame assemblies.
    Tip: Loosen set screw in pillow block bearing using a 1/8" Allen wrench. Slide pillow block bearing down pivot shaft.
    Item Description Qty.
    1 Footboard Assembly 1
    2 Side Frame Assembly 2
  3. Install bolts, backing washers, washers, and nuts securing footboard assembly to side frame assemblies using two 3/4" wrenches.
    Item Description Qty.
    1 Footboard Assembly 1
    2 Side Frame Assembly 2
    3 Nut, 1/2" Thin Lock 4
    4 Backing Washer 4
    5 Bolt, HHB.5x2.5 4

    Hand tighten hardware.

  4. Lift footboard linkage weldments and align with footboard assembly.
  5. Install pivot shafts and shaft collars securing footboard linkage weldments to footboard assembly. Tighten set screws in shaft collars using a 4mm Allen wrench.
    Item Description Qty.
    1 Footboard Linkage Weldment 2
    2 Footboard Assembly 1
    3 Pivot Shaft 2
    6 Shaft Collar 4

    Tighten hardware to 8-10 ft-lb / 10.8-13.5 Nm.

  6. Install bolts and washers securing footboard to footboard assembly using a 9/16" wrench.
    Item Description Qty.
    1 Footboard 1
    2 Footboard Assembly 1
    3 Washer, 3/8" Flat 4
    4 Bolt, HHB.375x2.25 4

    Tighten hardware to 40-50 in-lb / 4.5-5.6 Nm.

Parent topic: Assembly Procedure