Weight Stack Assembly
This HDU station is not side specific. Weight stack can be set in either orientation (R or L). Orientate the weight stack to face the desired direction.
- If equipped with shrouds, carefully remove the rear shroud from the front shroud's channels.
- Pull guide rod retainers/springs down and away from tower to release the guide rods.
- Leaving the cable connected and weight stack cushions in place, tilt guide rods slightly so the head plate assembly can be removed.
- Carefully tilt weight plates around the front shrouds and onto the guide rods.
- Replace the head plate assembly onto the guide rods.
- Return the guide rods, springs and retainers to their original position in the tower.
- Insert the rear shroud into the front shroud's channels and fasten with the shroud rivets.
- Remove the protective backing from the weight stack label, adhere to the weight stack from the top and peel off protective front.
