Level Unit

This procedure will level the unit by evenly adjusting the weight on the rear feet. Leveling the unit will eliminate rocking during use.
Note: References to left and right are from the users perspective during use.
  1. Verify foot plates are completely stopped.
  2. Grasp one of the rear covers and slowly lift the rear foot off the floor. Lower rear foot to the floor.
    Item Description Qty.
    1 Rear Cover 2
    2 Left Rear Foot 1
    3 Right Rear Foot 1
    4 Lift Here
  3. Grasp the other rear cover and slowly lift the rear foot off the floor. Lower rear foot to the floor.
    Note: Make note of either rear foot lifting off the floor easier than the other.
    If both rear feet lift off the floor evenly, secure both leveling foot jam nuts against the frame posts using a 17mm open-end wrench. Unit is leveled.

    Left leveling foot shown

    Item Description Qty.
    1 Frame Post 1
    2 Jam Nut 1
    3 Leveling Foot 1
    4 Turn Counter-Clockwise to Secure
  4. Adjust the weight of the rear feet using a 17mm open-end wrench.
    • If the left rear foot lifts up easier, Adjust the right leveling foot down.
    • If the right rear foot lifts up easier, Adjust the left leveling foot down.

    Left leveling foot shown

    Item Description Qty.
    1 Frame Post 1
    2 Leveling Foot Nut 1
    3 Leveling Foot 1
    4 Turn Clockwise to Adjust Leveling Foot Down
  5. Test the unit again for uneven weight on the rear feet. Adjust leveling foot nuts until each rear foot lifts with even force.
  6. Secure jam nuts using a 17mm open-end wrench. Unit is leveled.
Parent topic: Assembly Procedure - Total Body