Assembly Procedure

  1. Install wheel assembly to rail assembly using a 6 mm Allen wrench and a 13 mm open end wrench. Tighten to 4.3 ft. lbs. (5.8 Nm).
    Item Description Qty.
    1 Wheel assembly 2
    2 Rail assembly 2
  2. Install hook assembly to rear brace using a 5 mm Allen wrench. Tighten to 5 ft. lbs. (6.8 Nm).
    Item Description Qty.
    1 Bolt 1
    2 Hook assembly 1
    3 Rear brace 1
  3. Install left and right rail assembly to rear brace with four M6 x 15 mm bolts, using a 5 mm Allen wrench.
    Note: Do not fully tighten bolts at this time.
    Item Description Qty.
    1 Left and right rail assembly 2
    2 M6 x 15 mm bolt 4
    3 Rear brace 1
  4. Spread the seat rail assemblies apart and slide the seat assembly onto the seat rails.
    Item Description Qty.
    1 Seat assembly 1
    2 Seat rail 2
  5. Place the main assembly into position on seat rail assembly.
    Item Description Qty.
    1 Main assembly 1
    2 Rail assembly 1
    3 M8 x 45 mm bolt 8
    4 M8 washer 16
    5 M8 nut 8
    6 M8 Nylock nut 8
  6. Install eight M8 x 45 mm bolts, sixteen M8 washers, eight M8 nuts, and eight M8 Nylock nuts, using a 6 mm Allen wrench and 13 mm open end wrench.
    Note: Do not fully tighten bolts at this time.
    Note: Nylock Nuts MUST be outside the standard Nut and Washer to properly secure assembly
  7. Stand up rower vertically and tighten all hardware.
    Item Description Qty.
    1 Tighten to 3.5 ft. lbs. (4.9 Nm). 4
    2 Tighten to 6 ft. lbs. (8.3 Nm). 8
  8. Hook bungee cord onto hook assembly.
    Item Description Qty.
    1 Hook assembly 1
    2 Bungee cord 1
  9. Return rower to horizontal position.
  10. Fill tank with water before using. See Tank Filling Procedure.
Parent topic: Assembly