Belt routing

Verify belt is routed through top of pulley bracket and then route end of belt down to the top weight.

Lift top weight and verify that the position of the belt clamp (on the top weight) is aligned properly with the top pulley bracket.

Slide belt through slot in belt clamp.

Verify belt and insert are installed properly. Do not install the insert backwards.

Correct belt routing

Incorrect belt routing

Pull belt through clamp until input arm measures 31” from floor.

Measure from floor to lower edge of caution decal (located on foot bar).

	Description	Qty.
1	Foot bar	1
2	Caution decal	1

Pull belt tight and secure belt to clamp with the two set screws.

Torque set screws 300-350 lb-in.

Place weight stack pin in each plate to verify proper installation.

Simulate normal operation by lifting top weight up and down with out selecting any resistance.

Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the weight belt clamp.

Turn the Increment Weight Adjusting Knob to select 0 lbs or 0 kg.