Install cable

  1. Route cable through slot in top cover, through pulley bracket, and down through guide rod plate.
  2. Install two BHSCS and two pulley shaft bolts securing lower pulley assembly to pulley bracket using two 5/16” Allen wrenches.
    Description Qty
    1 Pulley shaft bolt 1
    2 BHSCS 1
    3 Lower Pulley assembly 1
    4 Pulley bracket 1
  3. Install two BHSCS and two pulley shaft bolts securing top two pulley assemblies to pulley bracket using two 5/16” Allen wrenches.
    Description Qty
    1 Pulley shaft bolt 2
    2 BHSCS 2
    3 Pulley assembly 2
    4 Pully bracket 1
  4. Squeeze sides of top weight cover together and lift up. Pull down on cable until it is tight. Install spiral pin connecting cable to top weight.
    Description Qty
    1 Top weight cover 1
    2 Spiral pin 1
  5. Verify the cable is moving smoothly.
  6. Install back panel.
  7. Install ten screws securing top covers (front and back) to frame using a Phillips screwdriver.
    Description Qty
    1 10-32 screw 8
    2 # 8 screw 2
    3 Top cover 2
    4 Back panel 1
Parent topic: If machine CANNOT fit through doorway