Cable routing

  1. Verify cable is routed through top of pulley bracket and then route cable end to top weight connector.
  2. Pull cable tight and secure in place with spiral pin using a 3/16” pin punch and a hammer.
    Item Description Qty
    1 Pulley bracket 1
    2 Cable 2
    3 Top weight connector 1
    4 Roll pin 1
    5 Weight selector pin 1
  3. Place weight stack pin in each plate to verify proper installation.
  4. Lift top weight up and down simulating normal operation (without selecting any resistance).
  5. Verify that the cable is moving smoothly and is routed straight from the pulley bracket to the top of the weight plate connector.
Parent topic: Assembly Procedure