Testing Operation

Use the following instructions to test the full resistance of the unit:

  1. Move the resistance lever down to lowest resistance.
  2. Verify foot plates are completely stopped.
  3. Hold the handrails to steady self while stepping into the foot plates.
  4. Begin striding.
  5. Verify the control panel will illuminate.
  6. Press the GO/Enter key.
  7. Verify level meter is at LEVEL 1 and resistance is low.
  8. Verify WATTS are displayed on display screen.
  9. Move the resistance lever up to LEVEL 5.
    Verify resistance is higher than LEVEL 1.
  10. Move the resistance lever up to LEVEL 10.
    Verify resistance is higher than LEVEL 5.
  11. Move the resistance lever down to LEVEL 1.
  12. Press the STOP/Review key to exit.
  13. Wait until foot plates come to a complete stop before dismounting unit.
    Warning: Moving parts and fall hazard.
    • To avoid serious injury wait until foot plates come to a complete stop before getting off unit.
    • The moving parts cannot be stopped immediately, the unit is not equipped with a free wheel.

    Hold handrails to steady self while stepping off unit.

Testing complete.
Parent topic: Assembly