Assemble Frame

  1. Install bolts, washers, and hex nuts securing rear support to base frame using an 8mm Allen wrench and a 17mm socket wrench.
    Item Description Qty.
    1 Base Frame 1
    2 Rear Support 1
    3 M10 Hex Nylock Nut 2
    4 3/8" Flat Washer 2
    5 M10 x 25mm Bolt 2

    Tighten bolts to 20-25 ft-lb (27-33 Nm).

  2. Install bolts, washers, and hex nuts securing front support to front upright using an 8mm Allen wrench and a 17mm socket wrench.
    Item Description Qty.
    1 Front Upright 1
    2 Front Support 1
    3 3/8" Flat Washer 2
    4 M10 Hex Nylock Nut 2
    5 M10 x 25mm Bolt 2

    Tighten bolts to 20-25 ft-lb (27-33 Nm).

  3. Install bolts, washers, and hex nuts securing front upright to base frame using an 8mm Allen wrench and a 17mm socket wrench.
    Item Description Qty.
    1 Base Frame 1
    2 Front Upright 1
    3 M10 x 25mm Bolt 2
    4 3/8" Flat Washer 2
    5 M10 Hex Nylock Nut 2
    6 Hole Plug 2

    Tighten bolts to 20-25 ft-lb (27-33 Nm).

  4. Install hole plugs to front upright using a rubber mallet.
  5. Install bolts, washers, and pivot shaft securing seat frame to base frame using an 8mm Allen wrench and a 17mm socket wrench.
    Item Description Qty.
    1 Base Frame 1
    2 Seat Frame 1
    3 Pivot Shaft 1
    4 3/8" Type A Flat Washer 2
    5 M10 x 25mm Bolt 2

    Tighten bolts to 20-25 ft-lb (27-33 Nm).

    Note: The pivot shaft has a flat end that aligns with the flat end on the pivot bracket.
  6. Place the handle through the wrist strap loop. Install bolts, washers, and hex nuts securing handle to front upright using an 8mm Allen wrench and a 17mm socket wrench.
    Item Description Qty.
    1 Front Upright 1
    2 Handle 1
    3 Wrist Strap 1
    4 M10 x 60mm Bolt 2
    5 3/8" Flat Washer 4
    6 M10 Hex Nylock Nut 2

    Tighten bolts to 20-25 ft-lb (27-33 Nm).

  7. Pull wrist strap loop up over the handle top and place placard plate down through it. Install bolts, washers, and hex nuts securing placard plate to handle using an 8mm Allen wrench and a 17mm socket wrench.
    Item Description Qty.
    1 Placard Plate 1
    2 Handle 1
    3 Wrist Strap 1
    4 3/8" Flat Washer 4
    5 M10 Hex Nylock Nut 2
    6 M10 x 25mm Bolt 2

    Tighten bolts to 20-25 ft-lb (27-33 Nm).

    Note: How wrist strap should appear once it has been installed.
Parent topic: Assembly Procedure